top of page
UCD-502 | High Concentration Hybrid Densifier
UCD-502 | High Concentration Hybrid Densifier
 
Features
  • It effectively reacts with concrete, providing integrated and durable treatment results.
  • It does not create a physical film on the concrete surface, allowing the treated concrete to "breathe."
  • It does not alter the appearance of the treated surface.
  • The treatment effect continues to improve over time.
  • It can be applied to both new and old concrete.
  • It is easy to apply before construction and easy to remove without residue.
  • Environmentally friendly product for concrete strength and durability

UCD-502 | High Concentration Hybrid Densifier

345,00$Precio

  • Volume: 5 Gallon (A)

    Contents: A=Densifier B=Water

    Mixed Ratio by Volume: 1A : 3B 

    Maximum Volume: 20 Gallon 

    • SURFACE PREPARATION 

      • Paint, oil residues, or latex on the surface to be treated must be thoroughly removed using appropriate equipment. 
      • Clean the surface before construction.
      • Concrete with cracks or structural defects larger than 2mm should be properly repaired before construction. 
      • Surfaces with moisture can be coated, but Surfaces completely soaked in water or with standing water cannot be coated. 
      • The Surface must be dried to allow penetration of the hardner. 
      • For new concrete, it is recommended to wait a minimum of 28 days for curing before application.

       

      WORKING CONDITIONS

      • Perform the construction on concrete surfaces with temperatures ranging from 5 to 35ºC. 
      • Do not perform the application on days with fast evaporation of the hardener, freezing conditions where the hardener could freeze, anticipated rainy weather, or days with strong winds.

       

      APPLICATION

      • Apply an appropriate amount of the reinforcing agent evenly and sufficiently to the concrete surface using a low-pressure sprayer. 
      • Only apply enough to ensure that the reinforcing agent does pool on the surface.
      • If the reinforcing agent accumulates on the surface, immediately remove it using a trower or roller. 
      • Avoid excessive application. Excessively applying the reinforcing agent can result in the formation of white spots and dust on the surface as it dries.

      Drying 

       

      • Allow a minimum 1 hour after product has dried before burnishing. Burnish after each application. Surfaces should be protected from excessive moisture and vehicular traffic for minimum 24 hours after application. Stain resistance begin 24 hours after application and full resistance is typically archieved in 7 days.

Best Offers

bottom of page